1. connect MP (serial cable, ctrl+B)
[mp00215a9a04db] MP>
MP MAIN MENU:
CO: Console
VFP: Virtual Front Panel
CM: Command Menu
CL: Console Log
SL: Show Event Logs
CSP: Connect to Service Processor
SE: Enter OS Session
HE: Main Help Menu
X: Exit Connection
System state Activity # of logs since boot
————— ——– ——————–
HPUX init process start 746
2. show display Front system LED : VFP command
LEDs | LOCATOR | SYSTEM | POWER
—————————————————————————–
| OFF | FLASH RED | ON GREEN
—————————————————————————–
Status | Fatal System State detected. Check System Event Log (SL) for error
| messages.
—————————————————————————–
3. execute dc command.( CM -> dc)
[mp00215a9a04db] MP> cm
[mp00215a9a04db] MP:CM> dc
DCThis command will restore all MP Configurations to their default values.
To restore specific configurations to their defaults use the following commands:
Remote Console Serial Port Modem configuration: CA -remote DEFAULT
MP IP configuration : LC -all DEFAULT
Remote Access Configuration : SA -all
DEFAULT Command Interface configuration : IT -all
DEFAULT MP Security configuration : SO -opt DEFAULT
MP Session configuration : IT -all DEFAULT
MP User configuration : UC -all DEFAULT
MP LDAP directory configuration : LDAP -all DEFAULT
SNMP Configuration : SNMP -all DEFAULT
Restore All MP configuration default values? (Y/[N]):
Restore All MP configuration default values? (Y/[N]): yy
-> All MP configuration will be reset to its default values.
-> Users may be disconnected in this process
Command execution may take 25 seconds.
-> MP IP configuration
-> Remote Console Serial Port Modem configuration
-> Paging configuration
-> Remote Access
-> MP Security configuration
*************************************************************************
This is a private system.
Do not attempt to login unless you are an authorized user.
Any authorized or unauthorized access or use may be monitored and can
result in criminal or civil prosecution under applicable law.
*************************************************************************
*************************************************************************
Only default users are configured. Use one of the following user/password pairs to login:
Admin/Admin Oper/Oper
*************************************************************************
MP login:
4. MP login and VFP , then red led were turn offed.
LEDs | LOCATOR | SYSTEM | POWER
—————————————————————————–
| OFF | OFF | ON GREEN
—————————————————————————–
Status | No code is executing. System is Off.
—————————————————————————–